Energy Driven Switch (Shunt Version)
- Radio module for wall box installation
- Active energy management
- Monitoring of all network parameters (Power, Energy, Voltage, Current, Power Factor)
- Prevention of electrical faults
- Control of heavy loads
- Wireless Technology: Z-Wave Plus
- Dimensions: 37x37x17 mm
With the WiDom flush-mounted relay, you can integrate existing electrical installations (e.g. lighting, airing systems…) into a Z-Wave network. Thus, the connected devices can still be controlled with the existing wall switch, but – thanks to Z-Wave – also via remote control, smartphone or sensor-controlled automation. The device can be used either at the point of entry of your electrical system, or on a section of the latter. Version S featuring an internal shunt resistor. In addition to Power measurements, the device also provides data for Energy, Voltage, Current and Power factor.
Besides, the WPSS module can implement an active energy-saving management policy defined by the user according to his energy consumption, or to the amount of energy produced by his solar power system.
The compact radio module is placed in a wall box right behind the normal switch. The switch is no longer directly connected to the load but acts as input device for the WiDom insert that is controlling the load. The switch only sends control signal to the insert which controls the load then again. The solution works with all switch design. You can use a momentary or a toggle switch. It’s recommended to use wall boxes with 65mm depth. But smaller boxes with only 45mm depth can be used also if there is enough space behind the switch. The available space depends on the size of the traditional switch, the dimensions of the wall box and the amount of additional cabling placed in this box.